SHIFT LEVER > INSPECTION |
| 1. INSPECT SHIFT LOCK CONTROL ECU |
![]() |
Measure the voltage according to the value(s) in the table below.
| *a | Component with harness connected (Shift Lock Control ECU) |
| Tester Connection | Switch Condition | Specified Condition |
| 4 (STP) - 1 (E) | Brake pedal depressed | 11 to 14 V |
| Brake pedal released | Below 1 V | |
| 5 (KLS+) - 1 (E) | 1. Ignition switch ACC and shift lever in P | Below 1 V |
| 2. Ignition switch ACC and shift lever not in P (Within approx. 1 second) | 7.5 to 10.5 V | |
| 3. Ignition switch ACC and shift lever not in P (After approx. 1 second) | 6 to 9 V | |
| 6 (ACC) - 1 (E) | Ignition switch ACC | 11 to 14 V |
| Ignition switch ON | 11 to 14 V | |
| Ignition switch off | Below 1 V | |
| 8 (IG) - 1 (E) | Ignition switch ON | 11 to 14 V |
| Ignition switch off | Below 1 V |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| 1 (E) - Body ground | When battery voltage not applied | Below 1 Ω |
| 2. INSPECT TRANSMISSION CONTROL SWITCH |
![]() |
Measure the resistance according to the value(s) in the table below when the shift lever is moved to each position.
| *a | Component without harness connected (Transmission Control Switch) |
| Tester Connection | Shift Position | Specified Condition |
| 1 (NSSD) - 2 (AT3) | 3 and 2 | Below 1 Ω |
| Except 3 and 2 | 10 kΩ or higher | |
| 1 (NSSD) - 3 (ATD) | Except 3 and 2 | Below 1 Ω |
| 3 and 2 | 10 kΩ or higher |
| 3. INSPECT SHIFT LOCK SOLENOID |
Disconnect the shift lock solenoid connector.
![]() |
Measure the resistance according to the value(s) in the table below when the shift lever is moved to each position.
| *a | Component without harness connected (Shift Lock Solenoid) |
| Tester Connection | Shift Position | Specified Condition |
| 4 (P) - 3 (E2) | P | 10 kΩ or higher |
| Except P | Below 1 Ω |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| 1 (SLS+) - 2 (SLS-) | When battery voltage not applied | 112 Ω |