Home › Brake › BRAKE SYSTEM (OTHER) › BRAKE MASTER CYLINDER (for LHD)

BRAKE MASTER CYLINDER (for LHD) > REASSEMBLY

for Preparation Click here



1. INSTALL BRAKE MASTER CYLINDER RESERVOIR STRAINER


2. INSTALL BRAKE MASTER CYLINDER RESERVOIR FILLER CAP ASSEMBLY


3. INSTALL BRAKE MASTER CYLINDER RESERVOIR SUB-ASSEMBLY
  1. Apply lithium soap base glycol grease to 2 new grommets.

  1. Install the 2 grommets onto the brake master cylinder reservoir sub-assembly.

  1. Install the brake master cylinder reservoir sub-assembly to the master cylinder body.



    C234469
  1. Fix the brake master cylinder in a vise between aluminum plates.

    NOTICE:
    Do not overtighten the vise.

  1. Using a pin punch 5 mm and a hammer, tap in the straight pin.