WATER PUMP > ON-VEHICLE INSPECTION |
| 1. REMOVE ENGINE UNDER COVER RH |
| 2. REMOVE FAN AND GENERATOR V BELT |
![]() |
Loosen bolts A and B.
Release the fan and generator V belt tension and remove the fan and generator V belt.
| 3. INSPECT ENGINE WATER PUMP ASSEMBLY |
Turn the pulley and check that the water pump bearing moves smoothly and quietly.
If necessary, replace the engine water pump assembly.
Make sure that there are no drops of coolant on the water pump housing.
If necessary, replace the engine water pump assembly.
| 4. INSTALL FAN AND GENERATOR V BELT |
Provisionally install the fan and generator V belt onto each pulley.
| 5. INSTALL ENGINE UNDER COVER RH |