Home › Engine / Hybrid System ยท 2NZ-FE › COOLING › WATER PUMP

WATER PUMP > ON-VEHICLE INSPECTION

for Preparation Click here



1. REMOVE ENGINE UNDER COVER RH


2. REMOVE FAN AND GENERATOR V BELT


    A116197E01
  1. Loosen bolts A and B.

  1. Release the fan and generator V belt tension and remove the fan and generator V belt.



3. INSPECT ENGINE WATER PUMP ASSEMBLY
  1. Turn the pulley and check that the water pump bearing moves smoothly and quietly.
    If necessary, replace the engine water pump assembly.

  1. Make sure that there are no drops of coolant on the water pump housing.
    If necessary, replace the engine water pump assembly.



4. INSTALL FAN AND GENERATOR V BELT
  1. Provisionally install the fan and generator V belt onto each pulley.

    NOTICE:
    1. Make sure that there is no foreign matter or liquid, such as oil, on the belt and pulleys.
    2. Make sure that the V belt is securely fitted into the rib grooves of the pulley.



5. INSTALL ENGINE UNDER COVER RH