STARTER > INSPECTION |
| 1. INSPECT STARTER ASSEMBLY |
Perform a pull-in test.
![]() |
Connect the battery to the magnet starter switch assembly as shown in the illustration. Check that the clutch pinion gear is extended.
If the clutch pinion gear does not move, replace the magnet starter switch assembly.
| *1 | Terminal 50 |
| *2 | Body |
![]() |
Inspect the clutch pinion gear return.
Disconnect the negative (-) lead from the starter body. Check that the clutch pinion gear returns.
If the clutch pinion gear does not return inward, replace the magnet starter switch assembly.
| *1 | Terminal 50 |
| *2 | Body |
Perform a no-load performance test.
Clamp the starter in a vise.
![]() |
Connect the battery and an ammeter to the starter as shown in the illustration.
| *1 | Terminal 50 |
| *2 | Terminal 30 |
| *3 | Body |
Check that the starter rotates smoothly and steadily with the clutch pinion gear extended.
Measure the current according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| Battery positive terminal - Terminal 30 - Terminal 50 | 11.5 V | Below 90 A |
| 2. INSPECT STARTER ARMATURE ASSEMBLY |
Check the commutator for an open circuit.
![]() |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| Segment - Segment | Always | Below 1 Ω |
| *1 | Segment |
Check the commutator for a short to ground.
![]() |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| Segment - Coil Core | Always | 10 kΩ or higher |
| *1 | Segment |
| *2 | Coil Core |
Check the commutator surface for dirt and burns.
If the surface is dirty or burnt, restore it with sandpaper (No. 400) or a lathe.
Check the commutator for circle runout.
![]() |
Place the commutator on V-blocks.
Using a dial indicator, measure the circle runout.
![]() |
Using a vernier caliper, measure the commutator diameter.
![]() |
Check that the undercut portion between the segments is free of foreign matter and measure its depth.
| 3. INSPECT STARTER BRUSH HOLDER ASSEMBLY |
![]() |
Using a vernier caliper, measure the brush length.
| 4. INSPECT STARTER CLUTCH SUB-ASSEMBLY |
![]() |
Hold the starter clutch sub-assembly, rotate the pinion gear clockwise, and check that it turns freely. Try to rotate the pinion gear counterclockwise and check that it locks.
If necessary, replace the starter clutch sub-assembly.
| *a | Free |
| *b | Lock |
| 5. INSPECT MAGNET STARTER SWITCH ASSEMBLY |
Check the plunger.
![]() |
Push in the plunger and check that it returns quickly to its original position.
If necessary, replace the magnet starter switch assembly.
| *1 | Plunger |
Check the holding coil for an open circuit.
![]() |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| Terminal 50 - Body | Always | Below 2 Ω |
| *1 | Terminal 50 |
| *2 | Body |