Home › Engine / Hybrid System ยท 2NZ-FE › STARTING › STARTER

STARTER > DISASSEMBLY

for Preparation Click here



1. REMOVE MAGNET STARTER SWITCH ASSEMBLY


    A250021
  1. Using a 7 mm socket wrench, remove the 2 bolts.



    A249983E01
  1. Remove the hook from the starter pinion drive lever while lifting the rear of the magnet starter switch assembly, and then remove the magnet starter switch assembly.
    Text in Illustration 
    *1
    Starter Pinion Drive Lever
    *2
    Hook



2. REMOVE STARTER YOKE ASSEMBLY


    A249977
  1. Using a 7 mm socket wrench, remove the 3 through bolts.

  1. Remove the starter yoke assembly.



3. REMOVE STARTER BRUSH HOLDER ASSEMBLY


    A248647
  1. Remove the starter commutator end frame assembly.



    A248649E01
  1. Remove the starter yoke assembly while holding down the starter armature assembly and the starter brush holder assembly with the handle of a hammer.

    HINT:
    The starter armature assembly will be attracted by the magnetic field of the starter yoke assembly, so the starter armature assembly is held with the handle of the hammer.

    Text in Illustration 
    *1
    Hammer



4. REMOVE STARTER ARMATURE ASSEMBLY


    A248650
  1. Remove the starter armature assembly from the starter brush holder assembly.



5. REMOVE STARTER CENTER BEARING CLUTCH SUB-ASSEMBLY


    A249978
  1. Remove the rubber seal from the starter drive housing assembly.



    A249979
  1. Remove the starter center bearing clutch sub-assembly from the starter drive housing assembly.



    A250735
  1. Disengage the 3 claws and remove the starter armature plate from the starter center bearing clutch sub-assembly.



    A248654
  1. Remove the 3 planet gears from the starter center bearing clutch sub-assembly.