STARTER > REASSEMBLY |
| 1. INSTALL STARTER CENTER BEARING CLUTCH SUB-ASSEMBLY |
![]() |
Apply high-temperature grease to the 3 planet gears and the starter center bearing clutch sub-assembly.
![]() | High-temperature Grease |
![]() |
Install the 3 planet gears to the pins without depressions on the starter center bearing clutch sub-assembly.
| *1 | Pins without Depressions |
![]() |
Engage the 3 claws and install the starter armature plate to the starter center bearing clutch sub-assembly.
![]() |
Align the depression in the starter drive housing assembly with the protrusion on the starter center bearing clutch sub-assembly and install the starter center bearing clutch subassembly.
| *1 | Depression |
| *2 | Protrusion |
Install the rubber seal to the starter drive housing assembly.
| 2. INSTALL STARTER BRUSH HOLDER ASSEMBLY |
![]() |
Install the starter commutator end frame assembly to the starter brush holder assembly as shown in the illustration.
![]() |
Spread the brushes on the starter brush holder assembly, and install the starter armature assembly to the starter brush holder assembly.
| 3. INSTALL STARTER ARMATURE ASSEMBLY |
![]() |
Install the starter yoke assembly while holding down the starter armature assembly and the starter brush holder assembly with the handle of a hammer.
| *1 | Hammer |
| 4. INSTALL STARTER YOKE ASSEMBLY |
![]() |
Align the depression in the starter yoke assembly with the protrusion on the starter center bearing clutch sub-assembly.
| *1 | Protrusion |
| *2 | Depression |
![]() |
Using a 7 mm socket wrench, install the starter yoke assembly with the 3 through bolts.
| 5. INSTALL MAGNET STARTER SWITCH ASSEMBLY |
![]() |
Catch the hook on the magnet starter switch assembly on the starter pinion drive lever from the top of the lever.
| *1 | Starter Pinion Drive Lever |
| *2 | Hook |
![]() |
Push down the back of the magnet starter switch assembly and connect it to the terminal C.
| *1 | Terminal C |
![]() |
Using a 7 mm socket wrench, install the magnet starter switch assembly with the 2 bolts.