Home › Power Source / Network ยท 1NZ-FE BATTERY / CHARGING › GENERATOR

GENERATOR > REMOVAL

for Preparation Click here



1. PRECAUTION

NOTICE:
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (Click here).



2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL


3. REMOVE NO. 2 CYLINDER HEAD COVER


4. REMOVE FAN AND GENERATOR V BELT


    A116197E01
  1. Loosen bolts A and B.

  1. Release the fan and generator V belt tension and remove the fan and generator V belt.



5. REMOVE GENERATOR ASSEMBLY


A249989E01
  1. Remove the terminal cap.

  1. Disconnect the connector and the harness clamp.

  1. Remove the nut and disconnect the wire harness from terminal B.
    Text in Illustration 
    *1
    Terminal B



    A244005E01
  1. Remove the belt adjusting slider fixing bolt A, nut B and the belt adjusting slider.



    A247897E01
  1. Remove the bolt A, screw B and the piping clamp.



    A244006
  1. Remove the fixing bolt and the generator assembly.