Home › Vehicle Interior › LIGHTING (INT) › BACK DOOR COURTESY SWITCH

BACK DOOR COURTESY SWITCH > INSPECTION

for Preparation Click here



1. INSPECT BACK DOOR LOCK ASSEMBLY (w/ Power Door Lock)


    E222051E01
  1. Measure the resistance according to the value(s) in the table below.
    Text in Illustration 
    *1
    Latch
    *a
    Locked
    *b
    Unlocked
    *c
    Component without harness connected
    (Back Door Lock Assembly)

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    2(ACT-) - 3(D+)
    Unlocked
    Below 1 Ω
    Locked
    10 kΩ or higher

    If the result is not specified, replace the back door lock assembly.



2. INSPECT BACK DOOR LOCK ASSEMBLY (w/o Power Door Lock)


    E232774E01
  1. Measure the resistance according to the value(s) in the table below.
    Text in Illustration 
    *1
    Latch
    *a
    Locked
    *b
    Unlocked
    *c
    Component without harness connected
    (Back Door Lock Assembly)

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    1(ACT-) - 2(D+)
    Unlocked
    Below 1 Ω
    Locked
    10 kΩ or higher

    If the result is not specified, replace the back door lock assembly.