STEERING GEAR > INSPECTION |
| 1. INSPECT TIE ROD END SUB-ASSEMBLY LH |
![]() |
Secure the tie rod end sub-assembly LH in a vise.
Install the nut onto the stud bolt.
Flip the ball joint back and forth 5 times.
Set a torque wrench to the nut, turn the ball joint continuously at a rate of 2 to 4 seconds per turn, and check the turning torque on the 5th turn.
| 2. INSPECT TIE ROD END SUB-ASSEMBLY RH |
| 3. INSPECT TOTAL PRELOAD |
![]() |
Using SST, secure the steering gear in a vise.
| *1 | Protective Tape |
Using SST, fully turn the steering rack right and left 1 to 2 times to settle it.
![]() |
Using SST and a torque wrench, turn the pinion at a fixed speed between 4 to 6 seconds and check the total turning torque.
| Tire Size | preload |
| 175/70R14 175/65R15 | 0.57 to 1.17 N*m (5.9 to 11.9 kgf*cm, 5.1 to 10.3 in.*lbf) |
| 175/65R14 185/60R15 | 0.6 to 1.2 N*m (6.1 to 12.2 kgf*cm, 5.3 to 10.6 in.*lbf) |