Home › Vehicle Exterior › DOOR / HATCH › BACK DOOR

BACK DOOR > INSPECTION

for Preparation Click here



1. INSPECT DOOR UNLOCK SWITCH SUB-ASSEMBLY (w/ Power Door Lock)


    B284623E01
  1. Check the resistance.
    Text in Illustration 
    *a
    Component without harness connected
    (Door Unlock Switch Sub-assembly)
    *b
    UNLOCK
    *c
    LOCK

    1. Measure the resistance according to the value(s) in the table below.

      Standard Resistance:
      Tester Connection
      Condition
      Specified Condition
      3 (L) - 4 (E)
      LOCK
      10 kΩ or higher
      OFF
      Below 1 Ω
      2 (UL) - 4 (E)
      UNLOCK
      10 kΩ or higher
      OFF
      Below 1 Ω

      If the result is not as specified, replace the door unlock switch.