Home › Vehicle Interior › HEATING / AIR CONDITIONING › AIR CONDITIONING SYSTEM (for Manual Air Conditioning System)

DTC    B1412    Ambient Temperature Sensor Circuit

for Preparation Click here


DESCRIPTION

The thermistor assembly (ambient temperature sensor) is installed in the front part of the cooler condenser assembly to detect the ambient temperature and control the air conditioner. The sensor connected to the air conditioning amplifier assembly detects fluctuations in the ambient temperature. This data is used for controlling the room temperature. The sensor sends a signal to the air conditioning amplifier assembly. The resistance of the thermistor assembly (ambient temperature sensor) changes in accordance with the cooler thermistor temperature (ambient temperature). As the temperature decreases, the resistance increases. As the temperature increases, the resistance decreases.
The air conditioning amplifier assembly applies a voltage (5 V) to the thermistor assembly (ambient temperature sensor) and reads voltage changes as changes in the resistance of the thermistor assembly (ambient temperature sensor).

DTC No.
DTC Detection Condition
Trouble Area
B1412
An open or short in the thermistor assembly (ambient temperature sensor) circuit.
  1. Thermistor assembly (ambient temperature sensor)
  2. Harness or connector
  3. Air conditioning amplifier assembly

WIRING DIAGRAM


E231083E01


INSPECTION PROCEDURE

1.READ VALUE USING INTELLIGENT TESTER
  1. Connect the intelligent tester to the DLC3.

  1. Turn the ignition switch to ON.

  1. Turn the intelligent tester on.

  1. Enter the following menus: Body / Air Conditioner / Data List.

  1. According to the display on the intelligent tester, read the Data List.

    Air Conditioner 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    Ambient Temp Sensor
    Ambient temperature sensor /
    Min.: -23.3°C (-9.94°F)
    Max.: 65.95°C (150.71°F)
    Actual ambient temperature is displayed
    -

    OK:
    The display is as specified in the normal condition column.

    Result 
    Result
    Proceed to
    OK (When troubleshooting according to the DTC)
    A
    OK (When troubleshooting according to Problem Symptoms Table)
    B
    NG
    C



B
PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)

C
Go to step 3
A


2.CHECK FOR DTC
  1. Clear the DTCs (Click here).

  1. Check for DTCs (Click here).

    OK:
    DTC B1412 is not output



NG
REPLACE AIR CONDITIONING AMPLIFIER ASSEMBLY (Click here)
OK

USE SIMULATION METHOD TO CHECK (Click here)  

3.INSPECT THERMISTOR ASSEMBLY (AMBIENT TEMPERATURE SENSOR)
  1. Inspect the thermistor assembly (ambient temperature sensor) (Click here).



NG
REPLACE THERMISTOR ASSEMBLY (AMBIENT TEMPERATURE SENSOR) (Click here)
OK


4.CHECK HARNESS AND CONNECTOR (THERMISTOR ASSEMBLY (AMBIENT TEMPERATURE SENSOR) - AIR CONDITIONING AMPLIFIER ASSEMBLY)
  1. Disconnect the A24 thermistor assembly (ambient temperature sensor) connector.

  1. Disconnect the F41 air conditioning amplifier assembly connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    A24-2 - F41-22 (TAM)
    Always
    Below 1 Ω
    A24-1 - F41-5 (SG-2)
    Always
    Below 1 Ω
    A24-2 - Body ground
    Always
    10 kΩ or higher
    A24-1 - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE AIR CONDITIONING AMPLIFIER ASSEMBLY (Click here)