REAR DOOR > ADJUSTMENT |

| *1 | Centering Bolt |
| *2 | Standard Bolt |
| 1. INSPECT REAR DOOR |
Check that the clearance measurements are within the standard ranges.

| Area | Specified Condition | Area | Specified Condition |
| A | 3.6 to 6.6 mm (0.141 to 0.259 in.) | D | 1.2 to 4.2 mm (0.0472 to 0.165 in.) |
| B | -1.5 to 1.5 mm (-0.0590 to 0.0590 in.) | E | 2.8 to 5.8 mm (0.110 to 0.228 in.) |
| C | 3.5 to 6.5 mm (0.137 to 0.255 in.) | F | 5.5 to 8.5 mm (0.216 to 0.334 in.) |
| 2. ADJUST REAR DOOR |
![]() |
Using SST, adjust the door horizontally and vertically by loosening the body side hinge bolts.
Tighten the body side hinge bolts after the adjustment.
![]() |
Using SST, adjust the door horizontally and vertically by loosening the door side hinge bolts.
Tighten the door side hinge bolts after the adjustment.
![]() |
Using a "TORX" socket wrench T40, adjust the striker position by slightly loosening the striker mounting screws and hitting the striker with a plastic-faced hammer.