Home › Vehicle Exterior › LIGHTING (EXT) › REAR COMBINATION LIGHT ASSEMBLY

REAR COMBINATION LIGHT ASSEMBLY > REMOVAL

for Preparation Click here


HINT:
  1. Use the same procedure for both the RH and LH sides.
  2. The procedure described below is for the LH side.



1. REMOVE REAR BUMPER COVER (for Sport Package)
(Click here)


2. REMOVE REAR BUMPER COVER (except Sport Package)
(Click here)


3. REMOVE REAR COMBINATION LIGHT SERVICE COVER


    E222122
  1. Using a moulding remover, disengage the 3 claws.

  1. Disengage the 2 guides to remove the rear combination light service cover.



4. REMOVE REAR COMBINATION LIGHT ASSEMBLY


    E229100
  1. Disconnect the connector.

  1. Remove the 2 nuts.



    E222124
  1. Disengage the clip and 2 guides to remove the rear combination light assembly.



5. REMOVE NO. 2 REAR COMBINATION LIGHT GUIDE
  1. Remove the No. 2 rear combination light guide from the body.