Home › Vehicle Exterior › LIGHTING (EXT) › REAR COMBINATION LIGHT ASSEMBLY

REAR COMBINATION LIGHT ASSEMBLY > DISASSEMBLY

for Preparation Click here



1. REMOVE REAR COMBINATION LIGHT BODY PACKING


    E234724
  1. Remove the rear combination light body packing.

    NOTICE:
    1. Be sure to remove all the traces of the old packing from the body.
    2. Do not reuse the removed packing. Be sure to install a new rear combination light body packing to prevent water ingress.



2. REMOVE TAIL AND STOP LIGHT BULB


    E234725
  1. Turn the rear combination light socket and wire sub-assembly with the bulb in the direction indicated by the arrow in the illustration to remove them.

  1. Remove the tail and stop light bulb from the rear combination light socket and wire sub-assembly.



3. REMOVE REAR TURN SIGNAL LIGHT BULB


    E228384
  1. Turn the rear combination light socket and wire sub-assembly with the bulb in the direction indicated by the arrow in the illustration to remove them.

  1. Remove the rear turn signal light bulb from the rear combination light socket and wire sub-assembly.



4. REMOVE BACK UP LIGHT BULB


    E228386
  1. Turn the rear combination light socket and wire sub-assembly with the bulb in the direction indicated by the arrow in the illustration to remove them.

  1. Remove the back up light bulb from the rear combination light socket and wire sub-assembly.



5. REMOVE REAR COMBINATION LIGHT SOCKET AND WIRE SUB-ASSEMBLY


    E234726
  1. Disengage the clamp to remove the rear combination light socket and wire sub-assembly.



6. REMOVE REAR COMBINATION LIGHT COVER


    E229106
  1. Remove the 2 screws and the rear combination light cover.



7. REMOVE REAR COMBINATION LIGHT PROTECTOR


    E229107
  1. Remove the 2 screws and the rear combination light protector.