Home › Vehicle Exterior › LIGHTING (EXT) › HIGH MOUNTED STOP LIGHT ASSEMBLY

HIGH MOUNTED STOP LIGHT ASSEMBLY > INSTALLATION

for Preparation Click here



1. INSTALL CENTER STOP LIGHT ASSEMBLY
  1. Install a new packing.



    E235167E01
  1. Engage the 4 claws to install a new clip.
    Text in Illustration 
    *a
    Upper Side (side with short claws)
    *b
    Lower Side (side with long claws)

    NOTICE:
    Make sure not to install the metal clip upside-down.

    HINT:
    Use the same procedure as for the opposite side.

  1. Connect the connector.



    E224877
  1. Engage the 4 claws of the metal clips and install the center stop light assembly.

    NOTICE:
    Make sure not to deform the packing at this point.



2. INSTALL REAR LIGHT COVER
  1. Engage the 6 claws to install the rear light cover.