Home › Vehicle Exterior › LIGHTING (EXT) › HEADLIGHT DIMMER SWITCH

HEADLIGHT DIMMER SWITCH > REMOVAL

for Preparation Click here



1. REMOVE SPIRAL CABLE SUB-ASSEMBLY
(Click here)


2. REMOVE WINDSHIELD WIPER SWITCH ASSEMBLY


    E229018E01
  1. Disconnect the 2 connectors.
    Text in Illustration 
    *1
    Protective Tape

  1. Using a screwdriver with its tip wrapped in protective tape, disengage the claw and remove the windshield wiper switch as shown in the illustration.

    NOTICE:
    If the claw is pushed with excessive force, it may break.



3. REMOVE HEADLIGHT DIMMER SWITCH ASSEMBLY


    E228392
  1. Disconnect the connector.

  1. Using pliers, expand the clamp as shown in the illustration.



    E229116
  1. While holding the clamp expand, disengage the claw and remove the headlight dimmer switch assembly as shown in the illustration.