Home › Vehicle Exterior › DOOR / HATCH › BACK DOOR OPENER SWITCH

BACK DOOR OPENER SWITCH > INSPECTION

for Preparation Click here



1. INSPECT BACK DOOR OPENER SWITCH ASSEMBLY


    B142645E06
  1. Measure the resistance according to the value(s) in the table below.
    Text in Illustration 
    *a
    Component without harness connected
    (Back Door Opener Switch assembly)

    Standard Resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    2 (E) - 3 (UL)
    Open switch pushed
    Below 1 Ω
    Open switch not pushed
    10 kΩ or higher

    1. If the result is not as specified, replace the back door opener switch assembly.