Home › Power Source / Network ยท NETWORKING › LIN COMMUNICATION SYSTEM

LIN COMMUNICATION SYSTEM > DATA LIST / ACTIVE TEST

for Preparation Click here



READ DATA LIST

NOTICE:
In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.

HINT:
Using the intelligent tester to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.

  1. Connect the intelligent tester to the DLC3.

  2. Turn the ignition switch to ON.

  3. Turn the intelligent tester on.

  4. Enter the following menus: Body / Main Body / Data List.

  5. According to the display on the intelligent tester, read the Data List.

    Main Body 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    Communication D-Door Motor
    Connection status between power window regulator motor assembly RH (for driver side)*1 or power window regulator motor assembly LH (for driver side)*2 and main body ECU (multiplex network body ECU) / STOP or OK
    STOP: No connection
    OK: Connection
    When there is a malfunction, a DTC is stored.
    The Number of DTC
    Number of trouble codes / Min.: 0, Max.: 255
    Number of stored DTCs displayed
    -

    1. *1: for RHD
    2. *2: for LHD