POWER DOOR LOCK CONTROL SYSTEM > OPERATION CHECK |
| CHECK POWER DOOR LOCK OPERATION |
Check the basic function.
Check that all doors lock when the door lock control switch (for manual operation) is turned to lock and all doors unlock when turned to unlock.
Check that all doors lock when the driver side door lock key cylinder is turned to lock using the key.
Check the key lock-in prevention function.
Turn the ignition switch to ON or ACC.
With the driver door open, check that all doors unlock immediately after the door lock knob for the driver door is pressed.
With the driver door open, check that all doors unlock immediately after the lock side of the door control switch (for manual operation) is pressed.
With the driver door open, press the driver door lock knob and hold it for 2 seconds or more, then close the driver door and check that all doors unlock.
Check the security function of the door lock control system.
Close all doors and leave the driver door window open so that the door control switch can be operated from outside the vehicle. (Step 1)
Open the driver door and remove the key from the vehicle. With the door still open, lock the door using the lock knob. Close the driver door. Then, check that the doors do not unlock when the unlock side of the door control switch (for manual operation) is pressed from outside the vehicle.
Starting from Step 1, with the key outside the vehicle, close and lock the driver door using the mechanical key. Then, check that the doors do not unlock when the unlock side of the door control switch (for manual operation) is pressed from outside the vehicle.
Starting from Step 1, with the key outside the vehicle, close and lock the driver door using wireless door lock or entry lock operation. Then, check that the doors do not unlock when the unlock side of the door control switch (for manual operation) is pressed from outside the vehicle.
Check the illumination function.
Set the map light switch to the DOOR position.
With all the doors locked, check that all doors unlock when the driver side door lock cylinder is turned to unlock using the key and that the map light turns on.
Check that the map light turns off in approximately 15 seconds after the doors have not been opened.
| CHECK BACK DOOR UNLATCH OPERATION |
Unlock the door locks.
Push the back door open switch on the back door outside handle.
Check that the back door unlatches.