Home › Vehicle Interior › LIGHTING (INT) › LIGHTING SYSTEM

LIGHTING SYSTEM > OPERATION CHECK

for Preparation Click here



CHECK ILLUMINATED ENTRY SYSTEM OPERATION

NOTICE:
Perform this inspection with the customize parameters at the initial setting.

  1. The operation and condition of this control are described below.

    Operation
    Condition
    Lighting
    Fade in and illuminate constantly
    Any door is opened when all the doors are closed.
    Map Light Assembly
    Illuminate for 15 seconds, and then fade out
    When any of the following conditions is met:
    1. The driver door is unlocked when the ignition switch is off and the driver door is closed and locked.*1
    2. The ignition switch is turned from ACC or ON to off when all doors are closed.
    3. All the doors are closed when any door is opened and the ignition switch is off.
    Fade out immediately
    The ignition switch is turned from off to ACC or ON when all the doors are closed.
    The driver door is locked when the ignition switch is off, all the doors are closed and the driver door is unlocked.*1
    Battery Saving
    When the doors remain in the same condition for 20 minutes and the key is not in the ignition key cylinder, the illumination turns off.

    1. *1: w/ Power Door Lock