Home › Vehicle Exterior › LIGHTING (EXT) › LIGHTING SYSTEM

LIGHTING SYSTEM > OPERATION CHECK

for Preparation Click here



AUTOMATIC LIGHT CONTROL SYSTEM OPERATION CHECK
  1. Turn the ignition switch to ON.

  2. Turn the light control switch to the AUTO position.

  3. Cover the light control sensor.

  4. Check that the low beam headlights, fog lights*1, clearance lights, taillights and license plate light come on.

  5. Uncover the light control sensor.

  6. Check that the low beam headlights, fog lights*1, clearance lights, taillights and license plate light go off.

    1. *1: w/ Fog Light


LIGHT AUTO TURN-OFF SYSTEM OPERATION CHECK
  1. When light control switch in AUTO, TAIL or HEAD position.

    1. Close the driver side door.

    2. Turn the ignition switch to ON.

    3. Turn the headlights, fog lights*1, clearance lights, taillights and license plate lights on.

    4. Turn the ignition switch off.

    5. Open the driver side door.

    6. Check that all of lights go off immediately.
      *1: w/ Fog Light


BATTERY SAVER SYSTEM OPERATION CHECK
  1. With the ignition switch off, turn the light control switch to AUTO, TAIL or HEAD to illuminate the headlights, fog lights*1, clearance lights, taillights and license plate lights.

  2. Check that the headlights, fog lights*1, clearance lights, taillights and license plate lights turn off when the doors and the light control switch remain in the same condition for 20 minutes or more.
    *1: w/ Fog Light