Home › Engine / Hybrid System ยท 2NZ-FE › INTAKE / EXHAUST › INTAKE MANIFOLD

INTAKE MANIFOLD > REMOVAL

for Preparation Click here



1. REMOVE THROTTLE WITH MOTOR BODY ASSEMBLY
(Click here)


2. REMOVE STUD BOLT


    A249588
  1. Using a "TORX" socket wrench E6, remove the 3 stud bolts.



3. DISCONNECT VENTILATION HOSE


    A249586
  1. Loosen the clip and disconnect the ventilation hose.



4. DISCONNECT UNION TO CONNECTOR TUBE HOSE


    A249587
  1. Loosen the clip and disconnect the union to connector tube hose.



5. REMOVE INTAKE MANIFOLD


    A259833
  1. Disengage the 2 wire harness clamps and separate the wire harness.



    A259832
  1. Remove the 2 bolts and the 2 wire harness brackets.



    A249593
  1. Disengage the wire harness clamp and separate the wire harness.



    A249594
  1. Remove the oil level dipstick.



    A105631
  1. Remove the 2 nuts, 3 bolts and the intake manifold.



    A249596
  1. Remove the gasket from the intake manifold.