EXHAUST MANIFOLD > INSTALLATION |
| 1. INSTALL EXHAUST MANIFOLD TO HEAD GASKET |
Install the new exhaust manifold to head gasket to the cylinder head assembly.
| 2. INSTALL EXHAUST MANIFOLD |
![]() |
Install the exhaust manifold with the 3 bolts and 2 nuts in the order shown in the illustration.
| 3. INSTALL MANIFOLD SUPPORT BRACKET |
Install the manifold support bracket with the 3 bolts.
| 4. INSTALL NO. 1 EXHAUST MANIFOLD HEAT INSULATOR |
Install the No. 1 exhaust manifold heat insulator with the 4 bolts.
Install the wire harness bracket with the bolt.
Engage the 2 wire harness clamps and install the wire harness.
| 5. INSTALL ENGINE MOVING CONTROL ROD |
Install the engine moving control rod with the bolt.
| 6. INSTALL EXHAUST PIPE GASKET |
![]() |
Using a plastic hammer and a wooden block, tap in a new exhaust pipe gasket until its surface is flush with the exhaust manifold.
| *1 | Exhaust pipe gasket |
| *2 | Wooden Block |
| *3 | Plastic Hammer |
| *4 | Exhaust Manifold |
| 7. INSTALL NO. 2 EXHAUST PIPE GASKET |
![]() |
Using a plastic hammer and a wooden block, tap in a new No. 2 exhaust pipe gasket until its surface is flush with the front exhaust pipe assembly.
| *1 | No. 2 Exhaust Pipe Gasket |
| *2 | Wooden Block |
| *3 | Plastic Hammer |
| *4 | Front Exhaust Pipe Assembly |
| 8. INSTALL FRONT EXHAUST PIPE ASSEMBLY |
![]() |
Using a vernier caliper, measure the free length of the compression spring.
Hang the front exhaust pipe assembly with the 3 exhaust pipe supports.
![]() |
Install the front exhaust pipe sub-assembly onto the exhaust manifold converter sub-assembly with the 2 compression springs and 2 bolts.
| *1 | Exhaust Manifold |
| *2 | Front Exhaust Pipe Assembly |
| *3 | Gasket |
| *a | Space between flanges: 8.5 mm (0.335 in.) |
![]() |
Using a vernier caliper, measure the free length of the compression spring.
![]() |
Connect the tail exhaust pipe assembly onto the front exhaust pipe assembly with the 2 compression springs and 2 bolts.
| *1 | Front Exhaust Pipe Assembly |
| *2 | Tail Exhaust Pipe Assembly |
| *3 | Gasket |
| *a | Space between flanges: 6.5 mm (0.256 in.) |
Pass the connector through the hole into the inside of the vehicle and install the oxygen sensor wire grommet.
Install the grommet and connect the oxygen sensor connector.
| 9. INSTALL FRONT FLOOR CENTER BRACE (w/ Side Mudguard) |
Install the front floor center brace onto the body with the 2 bolts.
| 10. INSTALL REAR CONSOLE BOX ASSEMBLY |
| 11. INSTALL HEATED OXYGEN SENSOR (for Sensor 1) |
| 12. INSPECT FOR EXHAUST GAS LEAK |