Home › Vehicle Exterior › LIGHTING (EXT) › LIGHTING SYSTEM

LIGHTING SYSTEM > CUSTOMIZE PARAMETERS

for Preparation Click here



CUSTOMIZE LIGHTING SYSTEM (EXT)

HINT:
The following items can be customized.

NOTICE:
  1. When the customer requests a change in a function, first make sure that the function can be customized.
  2. Record the current settings before customizing.

  1. Customizing with the intelligent tester.

    1. Connect the intelligent tester to the DLC3.

    2. Turn the ignition switch to ON.

    3. Turn the intelligent tester on.

    4. Enter the following menus: Body / Main Body / Utility / Customize / Light Control.

    5. Select the setting by referring to the table below.

      Light Control 
      Display
      Default
      Content
      Setting
      Relevant ECU
      Response Time*1
      Normal
      Changes the delay timing of lighting the taillights when going into a tunnel when the headlight dimmer switch is in the AUTO position.
      Normal or Long
      Main body ECU
      Sensitivity*1
      Normal
      Adjusts the sensitivity of the automatic light control system*A.
      Normal, Dark2, Dark1, Light1 or Light2
      Main body ECU
      Disp Ex ON Sen*1
      Normal
      Changes the ambient brightness level required to dim the lights such as the indicator lights*B.
      Normal, Dark2, Dark1, Light1 or Light2
      Main body ECU
      Disp Ex OFF Sen*1
      Normal
      Changes the ambient brightness level required to cancel the dimming of the lights such as the indicator lights*C.
      Normal, Dark2, Dark1, Light1 or Light2
      Main body ECU

      1. *1: w/ Automatic Light Control System

      HINT:
      The sensitivity adjustment may be difficult to confirm. Check by driving the customer's vehicle.


      *A 
      Lighting Brightness

      E107164

      Setting
      Dark2
      Dark1
      Normal
      Light1
      Light2

      *B 
      Brightness of lowering the lights

      E107164

      Setting
      Dark2
      Dark1
      Normal
      Light1
      Light2

      *C 
      Brightness when canceling the lowering of the lights

      E107164

      Setting
      Dark2
      Dark1
      Normal
      Light1
      Light2