Home › Vehicle Interior › DOOR LOCK › TRANSMITTER BATTERY

TRANSMITTER BATTERY > REPLACEMENT

for Preparation Click here



1. REMOVE TRANSMITTER HOUSING COVER


    B267250E01
  1. Using a screwdriver with its tip wrapped in protective tape, pry apart the transmitter housing cover.
    Text in Illustration 
    *1
    Protective Tape
    *2
    Housing Cover

    NOTICE:
    1. Do not use excessive force when prying apart the housing cover.
    2. Remove the transmitter housing cover while the switches face downward to prevent the switch knob from falling.



2. REMOVE DOOR CONTROL TRANSMITTER MODULE SET SUB-ASSEMBLY


    B266616
  1. Remove the door control transmitter module set.
    Text in Illustration 
    *1
    Protective Tape

    NOTICE:
    When replacing the transmitter battery, before starting work, remove static electricity that has built up in the body by touching, for example, the vehicle to prevent the electrical transmitter from being damaged.



3. REMOVE TRANSMITTER BATTERY


    B264882
  1. Disengage the hook and remove the transmitter battery cover.



    B264883
  1. Remove the battery (lithium battery: CR2016).

    NOTICE:
    1. When replacing the transmitter battery, before starting work, remove static electricity that has built up in the body by touching, for example, the vehicle to prevent the door control transmitter module set from being damaged.
    2. Do not push the terminals with your finger.
    3. Do not use excessive force when prying up the battery (lithium battery: CR2016) as this may damage the terminals.
    4. Do not touch the battery with wet hands. Water may cause it to rust.
    5. Do not touch or move any components inside the transmitter as this may interfere with its proper operation.



4. INSTALL TRANSMITTER BATTERY


    B264884
  1. Install a battery (lithium battery: CR2016) with the positive (+) side facing upward, as shown in the illustration.

    NOTICE:
    1. When replacing the transmitter battery, before starting work, remove static electricity that has built up in the body by touching, for example, the vehicle to prevent the door control transmitter module set from being damaged.
    2. Make sure that the positive (+) side and the negative (-) side of the transmitter battery are correctly matched with the transmitter terminals.
    3. Do not bend the transmitter battery electrode during insertion.
    4. Keep the transmitter cover interior free of dust and oil.



    B266612
  1. Engage the hook and install the transmitter battery cover.



5. INSTALL DOOR CONTROL TRANSMITTER MODULE SET SUB-ASSEMBLY


    B266617
  1. Install the door control transmitter module set into the transmitter housing case.

    NOTICE:
    1. When replacing the transmitter battery, before starting work, remove static electricity that has built up in the body by touching, for example, the vehicle to prevent the electrical transmitter from being damaged.
    2. The switches may not be able to operate normally when the door control transmitter module set is installed with keeping its rubber projections bent.



6. INSTALL TRANSMITTER HOUSING COVER


    B268614
  1. Install the transmitter housing cover onto the transmitter housing case securely.