Home › Vehicle Interior › SEAT BELT › OCCUPANT DETECTION SENSOR

OCCUPANT DETECTION SENSOR > INSPECTION

for Preparation Click here



1. INSPECT OCCUPANT DETECTION SENSOR


    B258852E05
  1. Measure the resistance according to the value(s) in the table below.
    Text in Illustration 
    *a
    Component without harness connected
    Separate Type Front Seat Cushion Pad (Occupant Detection Sensor)

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    1 - 3
    Front passenger side seat occupied
    Below 100 Ω
    Front passenger side seat not occupied
    1 MΩ or higher

    If the result is not as specified, replace the occupant detection sensor (separate type front seat cushion pad).