DTC P060E Internal Control Module Throttle Position Performance |
| DTC No. | DTC Detection Condition | Trouble Area |
| P060E | Either condition is met (1 trip detection logic):
| ECM |
| Required Sensors/Components | ECM |
| Frequency of Operation | Once per driving cycle |
| DMA communication error | Not detected |
| Either of following conditions 1 or 2 met | Condition 1 or 2 |
| 1. Difference of main throttle position and sub throttle position | 0.3 V or more |
| 2. Difference of main brake switch signal and sub brake switch signal | Different |
| Tester Display | Description |
| NORMAL |
|
| ABNORMAL |
|
| INCOMPLETE |
|
| N/A |
|
| 1.CHECK FOR DTC (DTC P060E) |
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON.
Turn the tester on.
Clear DTCs (Click here).
Turn the tester off.
Turn the ignition switch off.
Disconnect the tester.
Disconnect the cable from the negative (-) battery terminal and wait for 1 minute.
Connect the cable to the negative (-) battery terminal.
Connect the tester to the DLC3.
Turn the ignition switch to ON and turn the tester on.
Wait 16 seconds or more.
Enter the following menus: Powertrain / Engine and ECT / DTC.
Read DTCs.
|
| ||||
| OK | ||
| ||