Home › Drivetrain ยท C54 MANUAL TRANSMISSION / TRANSAXLE › MANUAL TRANSAXLE OIL

MANUAL TRANSAXLE OIL > REPLACEMENT

for Preparation Click here



1. DRAIN MANUAL TRANSAXLE OIL
  1. Remove the manual transmission filler plug and the gasket.

  1. Remove the drain plug sub-assembly and gasket, and then drain the manual transaxle oil.

  1. Install a new gasket and the drain plug sub-assembly.

    Torque:
    39 N*m{ 400 kgf*cm , 29 ft.*lbf }



2. ADD MANUAL TRANSAXLE OIL


    D025304E50
  1. Add manual transmission oil until the oil level is within 5 mm (0.197 in.) from the bottom of the manual transmission filler plug opening.
    Text in Illustration 
    *a
    0 to 5 mm (0 to 0.197 in.)

    Standard capacity (Reference):
    1.9 liters (2.0 US qts, 1.7 Imp. qts)

    Gear oil type:
    Toyota Genuine Manual Transmission Gear Oil "LV GL-3 and SAE 75W-90" or "API GL-4 and SAE 75W"

  1. Check for oil leakage when the oil level is low.

  1. Install the transmission filler plug and a new gasket.

    Torque:
    39 N*m{ 400 kgf*cm , 29 ft.*lbf }



3. INSPECT FOR MANUAL TRANSAXLE OIL


D025304E50
Text in Illustration 
*a
0 to 5 mm (0 to 0.197 in.)
  1. Stop the vehicle in a level place.

  1. Remove the manual transmission filler plug and the gasket.

  1. Check that the oil surface is within 5 mm (0.197 in.) of the bottom of the manual transmission filler plug opening.

    NOTICE:
    1. Excessively large or small amounts of oil may cause problems.
    2. After replacing the oil, drive the vehicle and check the oil level again.

  1. Check for oil leakage when the oil level is low.

  1. Install the manual transmission filler plug and a new gasket.

    Torque:
    39 N*m{ 400 kgf*cm , 29 ft.*lbf }



4. INSPECT FOR MANUAL TRANSAXLE OIL LEAK