DTC P1607 Cruise Control Input Processor |
| DTC No. | DTC Detection Condition | Trouble Area |
| P1607 | ECM CPUs malfunction (1 trip detection logic) | ECM |
| Required Sensors/Components (Main) | ECM |
| Required Sensors/Components (Related) | Cruise control |
| Frequency of Operation | Continuous |
| Cruise control | Prohibited |
| Either of following conditions 1 or 2 met | - |
| 1. Cruise control | Operating |
| 2. Low speed control | Operating |
| Tester Display | Description |
| NORMAL |
|
| ABNORMAL |
|
| INCOMPLETE |
|
| N/A |
|
| 1.CHECK FOR DTC (DTC P1607) |
Connect the intelligent tester to the DLC3.
Turn the ignition switch on.
Turn the tester on.
Clear DTCs (Click here).
Turn the tester off.
Turn the ignition switch off.
Disconnect the tester.
Disconnect the cable from the negative (-) battery terminal and wait for 1 minute.
Connect the cable to the negative (-) battery terminal.
Connect the tester to the DLC3.
Turn the ignition switch to ON and turn the tester on.
Wait 16 seconds or more.
Enter the following menus: Powertrain / Engine and ECT / DTC.
Read DTCs.
|
| ||||
| OK | ||
| ||