FRONT CRANKSHAFT OIL SEAL > INSTALLATION |
| 1. INSTALL OIL PUMP SEAL |
Apply MP grease to the lip of a new oil pump seal.
![]() |
Using SST and a hammer, tap in the timing chain cover oil seal until its surface is flush with the timing chain cover edge.
| 2. INSTALL CRANKSHAFT DAMPER SUB-ASSEMBLY |
Align the pin hole of the crankshaft damper with the pin and install the crankshaft damper sub-assembly.
Provisionally install the bolt.
Using 2 SST, tighten the bolt while holding the crankshaft damper sub-assembly.
| 3. INSTALL ENGINE MOUNTING INSULATOR SUB-ASSEMBLY RH |
Install the engine mounting insulator sub-assembly RH with the 4 bolts and 2 nuts.
| 4. INSTALL FAN AND GENERATOR V BELT |
Provisionally install the fan and generator V belt onto each pulley.
| 5. ADJUST FAN AND GENERATOR V BELT |
![]() |
Insert an adjusting bar between the engine mounting bracket and generator assembly. Pull the adjusting bar toward the vehicle front to adjust the generator V belt tension.
| *a | OK |
| *b | NG |
![]() | Front of Vehicle |
![]() |
First tighten bolt A, then tighten bolt B.
| 6. INSPECT FAN AND GENERATOR V BELT |
![]() |
Check the fan and generator V belt for wear, cracks or other signs of damage.
If any of the following defects is found, replace the fan and generator V belt.
![]() |
Check that the fan and generator V belt fits properly in the ribbed grooves.
| *a | Correct |
| *b | Incorrect |
![]() |
Inspect the V belt deflection and tension.
| *A | w/o Air Conditioner |
| *B | w/ Air Conditioner |
| Item | Specified Condition | |
| New belt | 8.0 to 9.0 mm (0.31 to 0.35 in) | |
| Used belt | 12.5 to 13.5 mm (0.49 to 0.53 in) | |
| Item | Specified Condition | |
| New belt | 700 to 800 N (71 to 82 kg, 157 to 180 lb) | |
| Used belt | 300 to 400 N (31 to 41 kg, 67 to 90 lb) | |
| 7. INSPECT FOR ENGINE OIL LEAK |
| 8. INSTALL ENGINE UNDER COVER RH (for Plastic Type) |
| 9. INSTALL NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY (for Metal Type) |
| 10. INSTALL FRONT WHEEL RH |