Home › Vehicle Exterior › WIPER / WASHER › WASHER MOTOR (for Rear Side)

WASHER MOTOR (for Rear Side) > INSTALLATION

for Preparation Click here



1. INSTALL WASHER JAR PROTECTOR
  1. Install the washer jar protector to the washer jar.



2. INSTALL REAR WASHER MOTOR AND PUMP ASSEMBLY
  1. Install the rear washer motor and pump.

  1. Connect the connector.

  1. Connect the washer hose.



3. ADD WASHER FLUID
  1. Add washer fluid to the washer jar.



4. INSTALL FRONT FENDER LINER RH

HINT:
Use the same procedure as for the LH side .



5. INSTALL FRONT WHEEL RH

Torque:
103 N*m{ 1050 kgf*cm , 76 ft.*lbf }