Home › Vehicle Exterior › WIPER / WASHER › WASHER NOZZLE (for Front Side)

WASHER NOZZLE (for Front Side) > ON-VEHICLE INSPECTION

for Preparation Click here



1. INSPECT WASHER NOZZLE SUB-ASSEMBLY (for LHD)


  1. With the engine running, check where the washer fluid hits the windshield.


    E229456E01


    Standard:

    Area
    Measurement
    Area
    Measurement
    A
    89 mm (3.50 in.)
    C
    39 mm (1.53 in.)
    B
    204 mm (8.03 in.)
    D
    18 mm (0.708 in.)

    OK:
    Washer fluid hits the windshield in the areas as shown in the illustration.

    If the result is not as specified, adjust the washer nozzle sub-assembly.



2. INSPECT WASHER NOZZLE SUB-ASSEMBLY (for RHD)


  1. With the engine running, check where the washer fluid hits the windshield.


    E221563E01


    Standard:

    Area
    Measurement
    Area
    Measurement
    A
    75 mm (2.95 in.)
    C
    36 mm (1.41 in.)
    B
    160 mm (6.29 in.)
    D
    14 mm (0.551 in.)

    OK:
    Washer fluid hits the windshield in the areas as shown in the illustration.

    If the result is not as specified, adjust the washer nozzle sub-assembly.