Home › Vehicle Interior › METER / GAUGE / DISPLAY › COMBINATION METER

COMBINATION METER > REMOVAL

for Preparation Click here



1. PRECAUTION

NOTICE:
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work (Click here).



2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL


3. REMOVE NO. 1 INSTRUMENT CLUSTER FINISH PANEL


    B284246
  1. Disengage the 5 clips and remove the instrument cluster finish panel.



4. REMOVE COMBINATION METER ASSEMBLY


    E222024
  1. Remove the 2 screws.

  1. Disengage the 2 clips and the 2 guides.



    E222025
  1. Disconnect the 2 connectors and remove the combination meter assembly.