Home › Vehicle Exterior › EXTERIOR PANELS / TRIM › REAR DOOR BELT MOULDING

REAR DOOR BELT MOULDING > REMOVAL

for Preparation Click here


HINT:
  1. Use the same procedure for both the RH and LH side.
  2. The procedure described below is for the LH side.



1. REMOVE REAR DOOR FRAME GARNISH

HINT:
Use the same procedure as for the RH side .



2. REMOVE REAR DOOR WINDOW REGULATOR HANDLE ASSEMBLY (w/o Power Window)

HINT:
Use the same procedure as for the RH side .



3. REMOVE REAR DOOR ARMREST BASE UPPER PANEL (w/o Power Window)

HINT:
Use the same procedure as for the RH side .



4. REMOVE REAR DOOR ARMREST BASE UPPER PANEL (w/ Power Window)

HINT:
Use the same procedure as for the RH side .



5. REMOVE REAR DOOR TRIM BOARD SUB-ASSEMBLY

HINT:
Use the same procedure as for the RH side .



6. REMOVE REAR DOOR SERVICE HOLE COVER (w/ Rear Speaker)

HINT:
Use the same procedure as for the RH side .



7. REMOVE REAR DOOR SERVICE HOLE COVER (w/o Rear Speaker)

HINT:
Use the same procedure as for the RH side .



8. REMOVE REAR DOOR WINDOW DIVISION BAR SUB-ASSEMBLY

HINT:
Use the same procedure as for the RH side .



9. REMOVE REAR DOOR GLASS SUB-ASSEMBLY

HINT:
Use the same procedure as for the RH side .



10. REMOVE REAR DOOR GLASS RUN

HINT:
Use the same procedure as for the RH side .



11. REMOVE REAR DOOR GLASS OUTER WEATHERSTRIP ASSEMBLY


    B272509E02
  1. Apply protective tape to the door panel in the area around the rear door glass outer weatherstrip.
    Text in Illustration 
    *1
    Protective Tape



    B272510E02
  1. Using a moulding remover, disengage the 5 claws and remove the rear door glass outer weatherstrip.
    Text in Illustration 
    *1
    Moulding Remover