Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › VEHICLE STABILITY CONTROL SYSTEM (for Built-in Type Yaw Rate Sensor)

DTC    C1419    Acceleration Sensor Internal Circuit

DTC    C1435    Yaw Rate Sensor Internal Circuit

for Preparation Click here


DESCRIPTION

The skid control ECU (brake actuator assembly) receives signals from the yaw rate and deceleration sensor (airbag sensor assembly) via the CAN communication system.
The yaw rate and deceleration sensor (airbag sensor assembly) has a built-in deceleration sensor and detects the vehicle's condition using 2 circuits (GL1, GL2).
If there is trouble in the bus lines between the yaw rate and deceleration sensor (airbag sensor assembly) and the CAN communication system, DTCs U0124 (Lost Communication with Lateral Acceleration Sensor Module) are set.
These DTCs are also output when calibration has not been completed.

DTC No.
DTC Detection Condition
Trouble Area
C1419
A data malfunction signal is received from the acceleration sensor.
Yaw rate and deceleration sensor (Airbag sensor assembly)
C1435
A data malfunction signal is received from the yaw rate sensor.
Yaw rate and deceleration sensor (Airbag sensor assembly)

WIRING DIAGRAM

Refer to DTCs C1232, C1243, C1245 and C1473 .

INSPECTION PROCEDURE

NOTICE:
  1. When replacing the brake actuator assembly, perform zero point calibration (Click here).
  2. Inspect the fuses for circuits related to this system before performing the following inspection procedure.

HINT:
When U0124 and/or U0126 is output together with C1419 and/or C1435, inspect and repair the trouble areas indicated by U0124 and/or U0126 first (Click here).

1.REPLACE YAW RATE AND DECELERATION SENSOR (AIRBAG SENSOR ASSEMBLY)
  1. Replace the yaw rate and deceleration sensor (airbag sensor assembly) (Click here).

    NOTICE:
    Check the yaw rate and deceleration sensor (airbag sensor assembly) signal after replacement (Click here).

    HINT:
    If troubleshooting has been carried out according to the Problem Symptoms Table, refer back to the table and proceed to the next step (Click here).


NEXT

END