CAN COMMUNICATION SYSTEM (for Separate Type Yaw Rate Sensor) > ABS and Traction Actuator (Skid Control ECU) Communication Stop Mode |
| Detection Item | Symptom | Trouble Area |
| ABS and Traction Actuator (Skid Control ECU) Communication Stop Mode | Either condition is met:
|
|

| 1.CHECK FOR OPEN IN CAN BUS WIRE (SKID CONTROL ECU (BRAKE ACTUATOR ASSEMBLY) BRANCH WIRE) |
![]() |
Disconnect the A54 skid control ECU (brake actuator assembly) connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| A54-25 (CANH) - A54-14 (CANL) | Ignition switch off | 54 to 69 Ω |
| *a | Front view of wire harness connector (to Skid Control ECU (Brake Actuator Assembly)) |
|
| ||||
| OK | |
| 2.CHECK HARNESS AND CONNECTOR (POWER SOURCE CIRCUIT) |
![]() |
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| A54-12 (+BS) - Body ground | Always | 11 to 14 V |
| A54-24 (BM) - Body ground | Always | 11 to 14 V |
| A54-34 (IG1) - Body ground | Ignition switch ON | 11 to 14 V |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| A54-1 (GND1) - Body ground | Always | Below 1 Ω |
| A54-13 (GND2) - Body ground | Always | Below 1 Ω |
| *a | Front view of wire harness connector (to Skid Control ECU (Brake Actuator Assembly)) |
|
| ||||
| OK | ||
| ||