Home › Drivetrain ยท U340E AUTOMATIC TRANSMISSION / TRANSAXLE › DIFFERENTIAL CASE

DIFFERENTIAL CASE > INSPECTION

for Preparation Click here



1. INSPECT DIFFERENTIAL SIDE GEAR BACKLASH


    C081322E01
  1. Using a dial indicator, measure the front differential side gear backlash while holding 1 pinion gear toward the case.

    Standard backlash:
    0.05 to 0.20 mm (0.00197 to 0.00787 in.)

    If the backlash is outside the specifications, install the correct front differential side gear thrust washer to the front differential side gear.

  1. Referring to the table below, select front differential side gear thrust washers which will ensure that the backlash is within the specifications for both sides.

    Thrust Washer Thickness:
    Part No.
    Thickness
    mm (in.)
    41361-17010
    0.95 (0.0374)
    41361-17020
    1.00 (0.0394)
    41361-17030
    1.05 (0.0413)
    41361-17040
    1.10 (0.0433)
    41361-17050
    1.15 (0.0453)
    41361-17060
    1.20 (0.0472)

    If the backlash is not within the specifications, install a front differential side gear thrust washer of a different thickness.