Home › Vehicle Exterior › WINDOW / GLASS › REAR POWER WINDOW SWITCH

REAR POWER WINDOW SWITCH > REMOVAL

for Preparation Click here


HINT:
  1. Use the same procedure for both the RH and LH side.
  2. The procedure described below is for the RH side.



1. REMOVE REAR DOOR ARMREST BASE UPPER PANEL


    B271671
  1. Using a moulding remover, disengage the 9 claws and 3 guides.

  1. Disconnect the connector and remove the rear armrest base upper panel.



2. REMOVE REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY


    B272651E02
  1. Using a screwdriver with its tip wrapped in protective tape, disengage the 2 claws and remove the rear power window regulator switch.
    Text in Illustration 
    *1
    Protective Tape