Home › Power Source / Network · NETWORKING › CAN COMMUNICATION SYSTEM (for Separate Type Yaw Rate Sensor)

CAN COMMUNICATION SYSTEM (for Separate Type Yaw Rate Sensor) > Power Steering ECU Communication Stop Mode

for Preparation Click here


DESCRIPTION


Detection Item
Symptom
Trouble Area
Power Steering ECU Communication Stop Mode
Either condition is met:
  1. "Power Steering (EPS)" is not displayed on "Bus Check".
  2. "Power Steering ECU Communication Stop Mode" in "DTC Combination Table" applies.
  1. Power source or inside power steering ECU assembly
  2. Power steering ECU assembly branch wire or connector
  3. Power steering ECU assembly

WIRING DIAGRAM


E236738E01


INSPECTION PROCEDURE

NOTICE:
  1. Inspect the fuses for circuits related to this system before performing the following inspection procedure.
  2. Turn the ignition switch off before measuring the resistances between CAN bus main wires and between CAN bus branch wires.
  3. Turn the ignition switch off before inspecting CAN bus wires for a ground short.
  4. After the ignition switch is turned off, check that the key reminder warning system are not operating.
  5. Before measuring the resistance, leave the vehicle as is for at least 1 minute and do not operate the ignition switch, any other switches or the doors. If any doors need to be opened in order to check connectors, open the doors and leave them open.

HINT:
  1. Operating the ignition switch, any other switches or a door triggers related ECU and sensor communication on the CAN. This communication will cause the resistance value to change.
  2. Even after DTCs are cleared, if a DTC is stored again after driving the vehicle for a while, the malfunction may be occurring due to vibration of the vehicle. In such a case, wiggling the ECUs or wire harness while performing the inspection below may help determine the cause of the malfunction.

1.CHECK FOR OPEN IN CAN BUS WIRE (POWER STEERING ECU ASSEMBLY BRANCH WIRE)


    E217716E01
  1. Disconnect the F6 power steering ECU assembly connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    F6-7 (CANH) - F6-8 (CANL)
    Ignition switch off
    54 to 69 Ω

    Text in Illustration 
    *a
    Rear view of wire harness connector
    (to Power Steering ECU Assembly)



NG
REPAIR OR REPLACE CAN BUS BRANCH WIRE OR CONNECTOR (POWER STEERING ECU ASSEMBLY BRANCH WIRE)
OK


2.CHECK HARNESS AND CONNECTOR (POWER SOURCE CIRCUIT)
E219743E01
  1. Disconnect the A42 power steering ECU assembly connector.

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Switch Condition
    Specified Condition
    A42-1 (PIG) - Body ground
    Always
    11 to 14 V
    F6-1 (IG) - Body ground
    Ignition switch ON
    11 to 14 V

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    A42-2 (PGND) - Body ground
    Always
    Below 1 Ω

Text in Illustration 
*a
Rear view of wire harness connector
(to Power Steering ECU Assembly)


NG
REPAIR OR REPLACE HARNESS OR CONNECTOR (POWER SOURCE CIRCUIT)
OK

REPLACE POWER STEERING ECU ASSEMBLY (Click here)