STEERING COLUMN ASSEMBLY (for LHD) > INSPECTION |
| 1. INSPECT PRELOAD |
![]() |
Secure the steering column assembly in a vise.
| *1 | Wooden Block |
Using SST and a torque wrench, turn the main shaft at a fixed speed of approximately 1 revolution every 4 seconds and measure the preload.
| 2. INSPECT STEERING LOCK OPERATION |
Remove the key and check that the steering lock function is activated.
![]() |
Insert the key, turn the ignition switch to ACC and check that the steering lock function has been deactivated.
| 3. INSPECT STEERING COLUMN ASSEMBLY |
![]() |
Check that the 2 bushings are securely installed to the steering column assembly.
If the bushings are deformed, missing or damaged, replace the steering column assembly with a new one.
![]() |
Check that the 2 capsules are securely installed to the steering column assembly as shown in the illustration.
| *1 | Capsule |