Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › VEHICLE STABILITY CONTROL SYSTEM (for Built-in Type Yaw Rate Sensor)

DTC    C1442    Invalid Data Received from Acceleration Sensor

DTC    C1443    Invalid Data Received from Yaw Rate Sensor

for Preparation Click here


DESCRIPTION

The skid control ECU (brake actuator assembly) receives signals from the yaw rate and deceleration sensor (airbag sensor assembly) via the CAN communication system.

DTC No.
DTC Detection Condition
Trouble Area
C1442
Both of the following is condition is met.
  1. With the IG1 terminal voltage between 9.5 and 17.4 V.
  2. An invalid data signal is transmitted continuously from the acceleration sensor for 10 seconds or more.
Yaw rate and deceleration sensor (airbag sensor assembly)
C1443
Both of the following is condition is met.
  1. With the IG1 terminal voltage between 9.5 and 17.4 V.
  2. An invalid data signal is transmitted continuously from the yaw rate and acceleration sensor for 10 seconds or more.

INSPECTION PROCEDURE

NOTICE:
When replacing the brake actuator assembly, perform zero point calibration (Click here).

1.CHECK DTC
  1. Clear the DTCs (Click here).

  1. Turn the ignition switch off.

  1. Start the engine and idle it for 60 seconds, and then stop the engine.

  1. Check if the same DTC is output (Click here).
    Result 
    Result
    Proceed to
    DTCs C1442 and/or C1443 are output
    A
    DTCs C1442 and C1443 are not output
    B



B
USE SIMULATION METHOD TO CHECK (Click here)
A

REPLACE YAW RATE AND DECELERATION SENSOR (AIRBAG SENSOR ASSEMBLY) (Click here)