SIDE AIRBAG SENSOR (for 5 Door) > REMOVAL |
| 1. PRECAUTION |
| 2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
| 3. REMOVE FRONT DOOR SCUFF PLATE RH |
![]() |
Disengage the 8 claws and remove the front door scuff plate.
| 4. REMOVE REAR DOOR SCUFF PLATE RH |
![]() |
Disengage the 5 claws and guide and remove the rear door scuff plate.
| 5. DISCONNECT FRONT DOOR OPENING TRIM WEATHERSTRIP RH |
![]() |
Remove the front door opening trim weatherstrip.
| 6. DISCONNECT REAR DOOR OPENING TRIM WEATHERSTRIP RH |
![]() |
Remove the rear door opening trim weatherstrip.
| 7. REMOVE CENTER PILLAR LOWER GARNISH RH |
![]() |
Disengage the 2 clips and the 2 claws.
Disengage the 2 guides and remove the center pillar lower garnish.
| 8. REMOVE SIDE AIRBAG SENSOR ASSEMBLY |
Check that the ignition switch is off.
Check that the cable is disconnected from the negative (-) battery terminal.
![]() |
Disconnect the connector from the side airbag sensor assembly.
Push and hold the white housing lock, and slide the yellow outer connector locking sleeve.

| *1 | Housing Lock | *2 | Outer Connector Locking Sleeve |
| *a | Slide | - | - |
Push and hold the white housing lock again, and slide the yellow outer connector locking sleeve to disconnect the connector.
![]() |
Remove the bolt and side airbag sensor assembly.