Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › KNEE AIRBAG ASSEMBLY

KNEE AIRBAG ASSEMBLY > REMOVAL

for Preparation Click here


CAUTION:
Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing (Click here).



1. PRECAUTION

NOTICE:
After turning the ignition switch off, waiting time may be required before disconnecting the cable from battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (Click here).



2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.



3. REMOVE LOWER STEERING COLUMN COVER

HINT:
Use the same procedure as for the LHD .



4. REMOVE NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY


    B284272
  1. Remove the 2 <A> screws.

  1. Disengage the claw and the guide and remove the instrument panel under cover.



5. REMOVE LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY
  1. Check that the ignition switch is off.

  1. Check that the cable is disconnected from the negative (-) battery terminal.

    CAUTION:
    Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.



    B287815E01
  1. Remove the 4 bolts.
    Text in Illustration 
    *1
    Protective Tape
    *2
    Locking Button

  1. Disengage the 6 claws to separate the lower No. 1 instrument panel airbag assembly.

  1. Using a screwdriver with its tip wrapped in protective tape, release the locking button.

  1. Disconnect the airbag connector to remove the lower No. 1 instrument panel airbag assembly.