Home › Vehicle Interior › HEATING / AIR CONDITIONING › CONDENSER

CONDENSER > REMOVAL

for Preparation Click here



1. RECOVER REFRIGERANT FROM REFRIGERATION SYSTEM
  1. Start up the engine.

  1. A/C switch on.

  1. Turn the blower switch to on.

  1. Operate the cooler compressor with an engine speed of approximately 1000 rpm for 5 to 6 minutes to circulate the refrigerant and collect the remaining compressor oil from each component, in the cooler compressor.

  1. Stop the engine.



    I106568E01
  1. Remove the caps from the service valves on the refrigerant line.
    Text in Illustration 
    *1
    High Pressure Service Valve
    *2
    Low Pressure Service Valve

  1. Connect the refrigerant recovery unit.

  1. Recover the refrigerant from the air conditioning system using a refrigerant recovery unit.

    HINT:
    Use the refrigerant recovery unit in accordance with the manufacturer's instruction manual.



2. REMOVE HEADLIGHT ASSEMBLY LH



3. REMOVE HEADLIGHT ASSEMBLY RH

HINT:
Use the same procedure as for the LH side.



4. REMOVE FRONT AIRBAG SENSOR
(Click here)


5. REMOVE RADIATOR UPPER SUPPORT SUB-ASSEMBLY


    I106000
  1. Remove the 2 clips.



    I106001
  1. Disconnect the connector.



    I106050
  1. Disengage the 2 clamps and disconnect the wire harness.



    I106252
  1. Disengage the 2 clamps and disconnect the hood lock control cable.



    I106710
  1. Remove the 4 bolts and the radiator support.



6. REMOVE NO. 1 COOLER COVER


    I106003
  1. Disengage the 2 guides and remove the cooler cover.



7. DISCONNECT NO. 1 COOLER REFRIGERANT DISCHARGE HOSE


    I106711E01
  1. Remove the bolt and disconnect the cooler refrigerant discharge hose from the cooler condenser
    Text in Illustration 
    *A
    w/o Fan Shroud Ventilation Duct
    *B
    w/ Fan Shroud Ventilation Duct

  1. Remove the O-ring from the cooler refrigerant discharge hose.

    NOTICE:
    Seal the openings of the disconnected parts using vinyl tape to prevent the entry of moisture and foreign matter.



8. REMOVE AIR DUCT (w/ Fan Shroud Ventilation Duct)


    I106713
  1. Disengage the 4 claws and remove the fan shroud ventilation duct from the cooler condenser.



9. DISCONNECT LIQUID TUBE SUB-ASSEMBLY A (w/o Fan Shroud Ventilation Duct)


    I106832
  1. Remove the bolt and disconnect the liquid tube from the cooler condenser.

  1. Remove the O-ring from the liquid tube

    NOTICE:
    Seal the openings of the disconnected parts using vinyl tape to prevent the entry of moisture and foreign matter.



10. DISCONNECT LIQUID TUBE SUB-ASSEMBLY B (w/ Fan Shroud Ventilation Duct)


    I106714
  1. Remove the 2 bolts and disconnect the liquid tube from the cooler condenser.

  1. Remove the O-ring from the liquid tube

    NOTICE:
    Seal the openings of the disconnected parts using vinyl tape to prevent the entry of moisture and foreign matter.



11. REMOVE COOLER CONDENSER ASSEMBLY


    I106716
  1. Disengage the 2 claws.

  1. Disengage the 2 guides and remove the cooler condenser.

    NOTICE:
    Do not damage the condenser or radiator when removing the cooler condenser.