Home › Drivetrain ยท DRIVE SHAFT / PROPELLER SHAFT › FRONT DRIVE SHAFT ASSEMBLY

FRONT DRIVE SHAFT ASSEMBLY > INSPECTION

for Preparation Click here



1. INSPECT FRONT DRIVE SHAFT ASSEMBLY


    C205473
  1. Check for noticeable looseness when turning the joint up and down, left and right, and in the thrust direction.

  1. Check for cracks, damage and grease leakage on the boot joint.

    HINT:
    Keep the drive shaft level while moving it.



    C205466E01
  1. Check dimension (A).

    Dimension (A):
    Engine Type
    LH
    RH
    1NZ-FE
    584.3 mm (23.00 in.)
    826.3 mm (32.53 in.)
    2NZ-FE
    589.3 mm (23.20 in.)
    829.3 mm (32.65 in.)