Home › Engine / Hybrid System · 2NZ-FE › ENGINE CONTROL › THROTTLE BODY

THROTTLE BODY > INSPECTION

for Preparation Click here



1. INSPECT THROTTLE BODY ASSEMBLY


    A062403E05
  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    1 (M-) - 2 (M+)
    20°C (68°F)
    0.3 to 100 Ω

    If the result is not as specified, replace the throttle body.
    Text in Illustration 
    *a
    Component without harness connected
    (Throttle Body Assembly)