Home › Engine / Hybrid System ยท 1NZ-FE › ENGINE CONTROL › ACCELERATOR PEDAL

ACCELERATOR PEDAL > INSTALLATION

for Preparation Click here



1. INSTALL ACCELERATOR PEDAL SENSOR ASSEMBLY (for LHD)
  1. Install the accelerator pedal sensor assembly with the 2 bolts.

    Torque:
    5.4 N*m{ 55 kgf*cm , 48 in.*lbf }

    NOTICE:
    1. Do not disassemble the accelerator or subjected to a strong impact, replace it.
    2. If a component has been dropped or subjected to a strong impact, replace it.

  1. Connect the connector of the accelerator pedal sensor assembly.



2. INSTALL ACCELERATOR PEDAL SENSOR ASSEMBLY (for RHD)
  1. Install the accelerator pedal sensor assembly with the 2 bolts.

    Torque:
    5.4 N*m{ 55 kgf*cm , 48 in.*lbf }

    NOTICE:
    1. Do not disassemble the accelerator or subjected to a strong impact, replace it.
    2. If a component has been dropped or subjected to a strong impact, replace it.

  1. Connect the connector of the accelerator pedal sensor assembly.