Home › Engine / Hybrid System ยท 1NZ-FE › ENGINE CONTROL › ACCELERATOR PEDAL

ACCELERATOR PEDAL > REMOVAL

for Preparation Click here



1. REMOVE ACCELERATOR PEDAL SENSOR ASSEMBLY (for LHD)


    A115383
  1. Disconnect the connector of the accelerator pedal sensor assembly.

  1. Remove the 2 bolts and the accelerator pedal sensor assembly.

    NOTICE:
    1. If a component has been dropped or subjected to a strong impact, replace it.
    2. Do not disassemble the accelerator pedal.



2. REMOVE ACCELERATOR PEDAL SENSOR ASSEMBLY (for RHD)


    A128266
  1. Disconnect the connector of the accelerator pedal sensor assembly.

  1. Remove the 2 bolts and the accelerator pedal sensor assembly.

    NOTICE:
    1. If a component has been dropped or subjected to a strong impact, replace it.
    2. Do not disassemble the accelerator pedal.