Home › Engine / Hybrid System ยท 2NZ-FE › ENGINE CONTROL › ACCELERATOR PEDAL

ACCELERATOR PEDAL > ON-VEHICLE INSPECTION

for Preparation Click here



1. INSPECT ACCELERATOR PEDAL SENSOR ASSEMBLY
  1. Connect the intelligent tester to the DLC3.

  1. Turn the ignition switch to ON.

  1. Turn the intelligent tester on.

  1. Enter the following menus: Powertrain / Engine and ECT / Data List / Accel Sensor Out No.1 and Accel Sensor Out No.2.

  1. Read the values displayed on the intelligent tester.

    Standard Voltage:
    Tester Display
    Condition
    Specified Condition
    Accel Sensor Out No.1
    Accelerator pedal is released
    0.5 to 1.1 V
    Accelerator pedal is fully depressed
    2.6 to 4.5 V
    Accel Sensor Out No.2
    Accelerator pedal is released
    1.2 to 2.0 V
    Accelerator pedal is fully depressed
    3.4 to 4.7 V

    If the result is not as specified, check the accelerator pedal sensor assembly, wire harness or ECM.